AC Control and dimming with Arduino

Recently I have been exploring working with AC control using the Arduino. I am planning on building a 6 channel, multi-function controller eventially but for now, here is a breadboard proof of concept video.

New Project: Autonomous IP Connected Quadcopter

I have been prototyping and testing subsystems and a lot of code for this project for a while and I should be getting into the build phase fairly soon. That means that it's time for a new project blog! As usual I will post a rundown of the expected challenges and my ideas in the next few days. Consider this post a place holder in the meantime. 

Basic Idea: In stages, create a Quadcopter capable of longrange self-stabilization and navigation as well as close-range fly-by-wire control via a standard 6 channel RC system.

Basic Method: Utilize an arduino mega microcontroller to poll sensors, control the motors, interface with RC radio, cell phone and provide self-stabilizing flight. I intend to use a DROID X cell phone to provide GPS data, secondary accelerometer data (for self-correction and increased accuracy) as well as to provide a 3G cellular link. The cell-phone will run a client program that will interface with a server on another computer (possibly on an android tablet) so that the copter can be given commands from anywhere with an internet connection. The cell-phone will also need to stream live (ish) video from it's camera, possibly using u-stream or a similar service.

Brief List of Foreseeable(lol) Problems: 

• Strapping an expensive cell phone to a machine intended to fly on it's own is perhaps not a great idea.
• Copter must support two flight modes (fly-by-wire assisted mode and autonomous mode) and be able to switch between them reliably in mid-flight.
• This build will have a lot of moving parts (literally and figuratively) and all the parts must communicate efficiently and accurately. I may have to develop some custom communication protocols.
• I would like to be able to land autonomously, so I will need a very accurate ground sensor (probably ultrasonic) since GPS is no where near accurate enough in the height axis. 
• Lag in the video and command stream could be significant so the copter will have to get commands as GPS waypoints rater then live motion commands when out of fly-by-wire range. 
• Deciding which jobs to handel on the Arduino, Phone and server will be crucial, I will probably end up creating a dependency and tolerance graph to help decide this.
• Fail-safe modes, the arduino and phone will have to have failsafe modes to fall back into if communication between each other and the with the server fails or becomes too degraded. Perhaps landing or returning to the last way point or a pre-designated waypoint depending on the situation.

Update on Wednesday, January 26, 2011 at 7:27PM by Kael Hankins

Here is the project blog: http://www.kaelhankins.com/autonomous-quadcopter/

Lots of updates to the Projects section

I have added my two current projects to the website, check them out by clicking projects at the top of the page. These are intended to be logs of my progress on different projects, complete with links pictures and later, videos!